Thin Kerf Angle Grinder Blades

[todaysman]

Anyone know if thin kerf blades, usually used for cutting stainless steel, are available in PP. And of course where?
Calling Ken Svay.

T

[Lucky Lucan]

I'm not sure what they are and a search showed what look like circular saw blades to me.The uncle does a lot of fabrication (inventing and making insane machines) so I'll ask him later if you describe them a bit better or post a picture.

[todaysman]

The normal blades for cutting steel are abrasive composite with a thickness of 2.8 mm. These are thinner so cut a lot quicker as they dont have to remove as much material or kerf.

[ken svay]

Available anywhere.
If in doubt about hardware shops go to the makita shop on mao tse tung,great shop.
They have american C clamps for $7.50 that cost nearly $40 in australia.
The shop is on mao tse tung on the right as you come from the river just past the chinese embassy.

[todaysman]

Thanks lads mucho appreciated the quick answers, will check out Makita shop tomorrow.

T

[Dad]

Yep I know I bought some in SR last time there, 3 months ago!